Create - 3Com Wireless LAN Switch WX1200 Command Reference Manual

624 C 24: B
HAPTER OOT

create

P C
ROMPT OMMANDS
The following command enters the configuration mode for the currently
active boot profile and configures the WX switch (in this example, an
WXR100) to boot using a TFTP server:
boot> change
Changing the default configuration is not recommended.
Are you sure that you want to proceed? (y/n)y
BOOT TYPE:
DEVICE:
FILENAME:
HOST IP:
LOCAL IP:
GATEWAY IP:
IP MASK:
FLAGS:
OPTIONS:
See Also
boot on page 621
create on page 624
delete on page 625
dhcp on page 626
display on page 628
next on page 633
Creates a new boot profile. (For information about boot profiles, see
display on page 628.)
Syntax — create
Defaults — The new boot profile has the same settings as the currently
active boot profile by default.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
[c]> n
[boot0:]> emac1
[default]> bootfile
[0.0.0.0]> 172.16.0.1
[0.0.0.0]> 172.16.0.21
[0.0.0.0]> 172.16.0.20
[0.0.0.0]> 255.255.255.0
[0x00000000]>
[run=nos;boot=0]>