3Com Wireless LAN Switch WX1200 Command Reference Manual page 368

368 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
Table 67 Defaults for Service Profile Parameters (continued)
Parameter
web-aaa-form
wep key-index
wep active-
multicast-index
wep active-unicast-
index
wpa-ie
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must configure the service profile before you can map it to
a radio profile. You can map the same service profile to more than one
radio profile.
You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.
Examples — The following command maps service-profile wpa_clients
to radio profile rp2:
WX4400# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
display service-profile on page 321
set service-profile auth-dot1x on page 373
set service-profile auth-fallthru on page 374
set service-profile auth-psk on page 375
set service-profile beacon on page 376
Radio Behavior When Parameter Set
Default Value to Default Value
Not configured For WebAAA users, serves the default
login web page or, if configured, the
SSID-specific login web page.
No keys Uses dynamic WEP rather than static WEP.
defined
If you configure a WEP key for static WEP,
MSS continues to also support dynamic
WEP.
1 Uses WEP key 1 for static WEP encryption
of multicast traffic if WEP encryption is
enabled and keys are defined.
1 Uses WEP key 1 for static WEP encryption
of unicast traffic if WEP encryption is
enabled and keys are defined.
disable Does not use the WPA IE in transmitted
frames.