Display Rfdetect Countermeasures - 3Com Wireless LAN Switch WX1200 Command Reference Manual

display rfdetect
countermeasures
WX4400# display rfdetect countermeasures
Total number of entries: 190
Rogue MAC
----------------- ----- ------------------ --------------- -------------
00:0b:0e:00:71:c0 intfr
00:0b:0e:03:00:80 rogue
Table 96 display rfdetect clients mac Output (continued)
Field
Typ
Dst
Last Rogue Status
Check
Displays the current status of countermeasures against rogues in the
Mobility Domain.
Syntax —

display rfdetect countermeasures

Defaults — None.
Access — Enabled.
History —Output no longer lists rogues for which countermeasures have
not been started in MSS Version 4.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.
Examples — The following example displays countermeasures status for
the Mobility Domain:
Type Countermeasures
Radio Mac
00:0b:0e:44:55:66 10.1.1.23
00:0b:0e:11:22:33 10.1.1.23
display rfdetect countermeasures
Description
Classification of the rogue device:
rogue—Wireless device that is on the network but is not
supposed to be on the network.
intfr—Wireless device that is not part of your network and
is not a rogue, but might be causing RF interference with
MAP radios.
known—Device that is a legitimate member of the
network.
MAC addressed to which the last 802.11 packet detected
from the client was addressed.
Number of seconds since the WX switch looked on the air for
the AP with which the rogue client is associated. The switch
looks for the client's AP by sending a packet from the wired
side of the network addressed to the client, and watching the
air for a wireless packet containing the client's MAC address.
WX-IPaddr Port/Radio
/Channel
dap 4/1/6
dap 2/1/11
541