Set Port Name; Set Port Negotiation - 3Com Wireless LAN Switch WX1200 Command Reference Manual

86 C 4: P
HAPTER ORT

set port name

set port negotiation

C
OMMANDS
Assigns a name to a port. After naming a port, you can use the port
name or number in other CLI commands.
Syntax —
set port port name name
— Number of a physical port. You can specify only one port.
port
— Alphanumeric string of up to 16 characters, with no
name name
spaces.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To simplify configuration and avoid confusion between a port's
number and its name, 3Com recommends that you do not use numbers
as port names.
Examples — The following command sets the name of port 7 to
adminpool:
WX1200# set port 7 name adminpool
success: change accepted.
See Also
clear port name on page 66
display port status on page 73
Disables or reenables autonegotiation on gigabit Ethernet or 10/100
Ethernet ports.
Syntax —
set port negotiation port-list {enable | disable}
port-list
autonegotiation on all the specified ports.
— Enables autonegotiation on the specified ports.
enable
— Disables autonegotiation on the specified ports.
disable
Defaults — Autonegotiation is enabled on all Ethernet ports by default.
— List of physical ports. MSS disables or reenables