Set Radio-Profile Active-Scan - 3Com Wireless LAN Switch WX1200 Command Reference Manual

348 C 11: M
HAPTER
set radio-profile
active-scan
A P C
ANAGED CCESS OINT OMMANDS
Even when association of 802.11b clients is disabled, if an 802.11b/g
radio detects a beacon from an 802.11b network, the radio enters
protection mode to guard against interference.
The set radio-profile 11g-only command does not affect the radio
support configured with the set port type ap command. For example, if
you configure a radio to be 802.11b only when you set the port type, the
set radio-profile 11g-only enable command does not enable 802.11g
support on the radio.
Examples — The following command configures the 802.11b/g radios in
radio profile rp1 to allow associations from 802.11g clients only:
WX4400# set radio-profile rp1 11g-only enable
success: change accepted.
See Also
display {ap | dap} config on page 290
display radio-profile on page 317
set port type ap on page 91
set radio-profile mode on page 362
Disables or reenables active RF detection scanning on the MAP radios
managed by a radio profile. When active scanning is enabled, MAP radios
look for rogue devices by sending probe any requests (probe requests
with a null SSID name), to solicit probe responses from other access
points.
Passive scanning is always enabled and cannot be disabled. During
passive scanning, radios look for rogues by listening for beacons and
probe responses.
Syntax — set radio-profile name active-scan {enable |
disable}
name — Radio profile name.
enable — Configures radios to actively scan for rogues.
disable
listening for beacons and probe responses.
— Configures radios to scan only passively for rogues by