Set Radio-Profile Wmm - 3Com Wireless LAN Switch WX1200 Command Reference Manual

370 C 11: M
HAPTER
set radio-profile
wmm
A P C
ANAGED CCESS OINT OMMANDS
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
Examples — The following command changes the short retry threshold
for radio profile rp1 to 3:
WX4400# set radio-profile rp1 short-retry 3
success: change accepted.
See Also
display radio-profile on page 317
set radio-profile mode on page 362
set radio-profile long-retry on page 359
Disables or reenables Wi-Fi Multimedia (WMM) on the MAP radios in a
radio profile.
Syntax — set radio-profile name wmm {enable | disable}
name — Radio profile name.
enable — Enables WMM.
disable
Defaults — WMM is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — When WMM is disabled, MAP forwarding prioritization is
optimized for SpectraLink Voice Priority (SVP) instead of WMM, and the
MAP does not tag packets it sends to the WX. Otherwise, classification
and tagging remain in effect. (For information, see the "Configuring
Quality of Service" chapter of the
Configuration
If you plan to use SpectraLink 802.11 phones, you must enable call
admission control (CAC). Use the set radio-profile wmm
admission-control command.
— Disables WMM.
Guide.)
Wireless LAN Switch and Controller