Set Radio-Profile Mode - 3Com Wireless LAN Switch WX1200 Command Reference Manual

362 C 11: M
HAPTER
set radio-profile
mode
A P C
ANAGED CCESS OINT OMMANDS
Creates a new radio profile, or disables or reenables all MAP radios that
are using a specific profile.
Syntax —
set radio-profile name [mode {enable | disable}]
radio-profile name
characters, with no spaces.
Use this command without the mode enable or mode disable
option to create a new profile.
mode enable
mode disable
Defaults — Each radio profile that you create has a set of properties with
factory default values that you can change with the other set
radio-profile commands in this chapter. Table 66 lists the parameters
controlled by a radio profile and their default values.
Table 66 Defaults for Radio Profile Parameters
Parameter
11g-only
active-scan
auto-tune
beacon-interval
countermeasures
dtim-interval
frag-threshold
long-retry
— Radio profile name of up to 16 alphanumeric
— Enables the radios that use this profile.
— Disables the radios that use this profile.
Radio Behavior When Parameter Set to
Default Value Default Value
disable Allows associations with 802.11g and
802.11b clients.
Note: This parameter applies only to
802.11b/g radios.
enable Sends probe any requests (probe requests
with a null SSID name) to solicit probe
responses from other access points.
enable Allows dynamic configuration of channel
and power settings by MSS.
100 Waits 100 ms between beacons.
Not configured Does not issue countermeasures against
any device.
1 Sends the delivery traffic indication map
(DTIM) after every beacon.
2346 Transmits frames up to 2346 bytes long
without fragmentation.
5 Sends a long unicast frame up to five times
without acknowledgment.