Set System Contact - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set system contact

Usage — When you first log in for the initial configuration of the WX
switch, the CLI provides a WX1200> or WX4400> prompt, depending on
your model. After you become enabled by typing enable and giving a
suitable password, the WX1200# or WX4400# prompt is displayed.
If you use the set system name command to change the default system
name, MSS uses that name in the prompt, unless you also change the
prompt with set prompt.
Examples — The following example sets the prompt from WX4400 to
happy_days:
WX4400# set prompt happy_days
success: change accepted.
happy_days#
See Also
clear prompt on page 39
display config on page 574
set system name on page 60
Stores a contact name for the WX switch.
Syntax — set system contact string
string — Alphanumeric string up to 256 characters long, with no
blank spaces.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
To view the system contact string, type the display system command.
Examples — The following command sets the system contact
information to tamara@example.com:
WX1200# set system contact tamara@example.com
success: change accepted.
set system contact 55