Set Rfdetect Ignore - 3Com Wireless LAN Switch WX1200 Command Reference Manual

558 C 19: RF D
HAPTER

set rfdetect ignore

C
ETECTION OMMANDS
See Also
clear rfdetect attack-list on page 534
display rfdetect ignore on page 546
set rf detect countermeasures on page 556
Configures a list of known devices to ignore during an RF scan. MSS does
not generate log messages or traps for the devices in the ignore list.
Syntax —
set rfdetect ignore mac-addr
mac-addr — BSSID (MAC address) of the device to ignore.
Defaults — MSS reports all unknown BSSIDs detected during an RF scan.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Use this command to identify third-party APs and other devices
you are already aware of and do not want MSS to report following RF
scans.
If you try to initiate countermeasures against a device on the ignore list,
the ignore list takes precedence and MSS does not issue the
countermeasures. Countermeasures apply only to rogue devices.
If you add a device that MSS has classified as a rogue to the permitted
vendor list or permitted SSID list, but not to the ignore list, MSS can still
classify the device as a rogue. Adding an entry to the permitted vendor
list or permitted SSID list merely indicates that the device is from an
allowed manufacturer or is using an allowed SSID. However, to cause
MSS to stop classifying the device as a rogue, you must add the device's
MAC address to the ignore list.
After you add a device that has been classified as a rogue to the ignore
list, the device remains classified as a rogue for at least 10 minutes. After
10 minutes, MSS reclassifies the device as an interfering device.