Display Spantree Blockedports - 3Com Wireless LAN Switch WX1200 Command Reference Manual

display spantree
blockedports
WX4400# display spantree blockedports vlan default
Port
------------------------------------------------------------------------
2
Number of blocked ports (segments) in VLAN 1 : 1
Examples — The following example shows the command output on a
WX switch with backbone fast convergence enabled:
WX4400# display spantree backbonefast
Backbonefast is enabled
See Also
set spantree backbonefast on page 411
Lists information about wireless LAN switch ports that STP has blocked on
one or all of its VLANs.
Syntax — display spantree blockedports [vlan vlan-id]
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, MSS displays information for blocked ports on all VLANs.
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Usage — The command lists information separately for each VLAN.
Examples — The following command shows information about blocked
ports on a WX switch for the default VLAN (VLAN 1):
Vlan Port-State
190 Blocking
The port information is the same as the information displayed by the
display spantree command. See Table 69 on page 399.
See Also
display spantree on page 398

display spantree blockedports

Cost Prio Portfast
4 128 Disabled
401