Set Service-Profile Wpa-Ie - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set service-profile
wpa-ie
Enables the WPA information element (IE) in wireless frames. The WPA IE
advertises the WPA authentication methods and cipher suites supported
by radios in the radio profile mapped to the service profile.
Syntax —
set service-profile name wpa-ie {enable | disable}
— Service profile name.
name
— Enables the WPA IE.
enable
— Disables the WPA IE.
disable
Defaults — The WPA IE is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — When the WPA IE is enabled, the default authentication
method is 802.1X. There is no default cipher suite. You must enable the
cipher suites you want the radios to support.
Examples — The following command enables the WPA IE in service
profile sp2:
WX4400# set service-profile sp2 wpa-ie enable
success: change accepted.
See Also
set service-profile auth-dot1x on page 373
set service-profile auth-psk on page 375
set service-profile cipher-ccmp on page 377
set service-profile cipher-tkip on page 378
set service-profile cipher-wep104 on page 379
set service-profile cipher-wep40 on page 380

set service-profile wpa-ie

391