Set Port Type Wired-Auth - 3Com Wireless LAN Switch WX1200 Command Reference Manual

94 C 4: P
HAPTER ORT
set port type
wired-auth
C
OMMANDS
The following command resets port 5 by clearing it:
WX1200# clear port type 5
This may disrupt currently authenticated users.
Are you sure? (y/n) [n]y
success: change accepted.
See Also
clear dap on page 64
clear port type on page 68
set {ap | dap} radio antennatype on page 334
set dap on page 81
set port type wired-auth on page 94
set radio-profile 11g-only on page 347
set system countrycode on page 56
Configures a WX switch port for a wired authentication user.
Before changing the port type from ap to wired-auth or from
wired-auth to ap, you must reset the port with the clear port type
command.
Syntax — set port type wired-auth port-list [tag tag-list]
[max-sessions num] [auth-fall-thru {last-resort | none |
web-portal}]
port-list
tag-list — One or more numbers between 1 and 4094 that
subdivide a wired authentication port into virtual ports.
num — Maximum number of simultaneous user sessions supported.
last-resort
requiring a username and password.
none — Denies authentication and prohibits the user from accessing
the network over this port.
web-portal
nonvolatile storage for secure login to the network.
— List of physical ports.
— Automatically authenticates the user, without
— Serves the user a web page from the MX switch's