Radius And; Commands By Usage - 3Com Wireless LAN Switch WX1200 Command Reference Manual

16
Commands by
Usage
RADIUS
C
OMMANDS
Use RADIUS commands to set up communication between a WX switch
and groups of up to four RADIUS servers for remote authentication,
authorization, and accounting (AAA) of administrators and network
users.
This chapter presents RADIUS commands alphabetically. Use Table 85 to
locate commands in this chapter based on their uses.
Table 85 RADIUS Commands by Usage
Type Command
RADIUS Client set radius client system-ip on page 491
clear radius client system-ip on page 487
RADIUS Servers set radius on page 490
set radius server on page 494
clear radius on page 486
clear radius server on page 489
Server Groups set server group on page 496
set server group load-balance on
page 497
clear server group on page 489
RADIUS Proxy set radius proxy client on page 492
set radius proxy port on page 493
clear radius proxy client on page 488
clear radius proxy port on page 488
(For information about RADIUS attributes, see the RADIUS appendix in
the Wireless LAN Switch and Controller Configuration
S
AND ERVER
G
ROUP
Guide.)