Display Config - 3Com Wireless LAN Switch WX1200 Command Reference Manual

574 C 20: F
HAPTER ILE

display config

M C
ANAGEMENT OMMANDS
Booted configuration:
Product model:
Table 105 describes the fields in the display boot output.
Table 105 Output for display boot
Field
Configured boot
version
Configured boot
image
Configured boot
configuration
Backup boot
configuration
Booted version
Booted image
Booted configuration Configuration filename MSS used to load the configuration
See Also
display version on page 576
reset system on page 582
set boot configuration-file on page 586
Displays the configuration running on the WX switch.
Syntax — display config [area area] [all]
area area — Configuration area. You can specify one of the
following:
aaa
acls
ap
arp
eapol
file:configuration
WX
Description
Software version the switch will run next time the software is
rebooted.
Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configuration filename MSS will use to boot next time the
software is rebooted.
The name of the configuration file to be used in the event
that MSS cannot read the configured boot configuration file
next time the software is rebooted.
Software version the switch is running.
Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
the last time the software was rebooted.