Set Radio-Profile Frag-Threshold - 3Com Wireless LAN Switch WX1200 Command Reference Manual

358 C 11: M
HAPTER
set radio-profile
frag-threshold
A P C
ANAGED CCESS OINT OMMANDS
See Also
display radio-profile on page 317
set radio-profile mode on page 362
Changes the fragmentation threshold for the MAP radios in a radio profile. The
fragmentation threshold specifies the maximum length a frame is allowed to
be without being broken into multiple frames before transmission.
Syntax —
set radio-profile name frag-threshold threshold
— Radio profile name.
name
threshold
from 256 through 2346.
Defaults — The default fragmentation threshold for MAP radios is 2346
bytes.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
Examples — The following command changes the fragmentation
threshold for radio profile rp1 to 1500 bytes:
WX4400# set radio-profile rp1 frag-threshold 1500
success: change accepted.
See Also
display radio-profile on page 317
set radio-profile mode on page 362
— Maximum frame length, in bytes. You can enter a value