Set Timedate - 3Com Wireless LAN Switch WX1200 Command Reference Manual

WX4400# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
WX4400# set system ip-address 10.10.20.20
success: change accepted.

set timedate

Examples — The following commands configure an IP interface on
VLAN taupe and configure the interface to be the system IP address:
See Also
clear system ip-address on page 136
display system on page 43
set interface on page 160
Sets the time of day and date on the wireless LAN switch.
Syntax — set timedate {date mmm dd yyyy [time hh:mm:ss]}
date mmm dd yyyy
mmm — month
dd — day
yyyy — year
time hh:mm:ss — System time, in hours, minutes, and seconds.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The day of week is automatically calculated from the day you set.
The time displayed by the CLI after you type the command might be slightly
later than the time you enter due to the interval between when you press
Enter and when the CLI reads and displays the new time and date.
Configure summertime before you set the time and date. Otherwise,
summertime's adjustment of the time will make the time incorrect, if the
date is within the summertime period.
— System date:
set timedate 193