Set Radius Client System-Ip - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set radius client
system-ip
retransmit — 3 (the total number of attempts, including the first
attempt)
timeout — 5 seconds
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can specify only one parameter per command line.
Examples — The following commands sets the dead time to 5 minutes,
the RADIUS key to goody, the number of retransmissions to 1, and the
timeout to 21 seconds on all RADIUS servers connected to the WX
switch:
WX1200# set radius deadtime 5
success: change accepted.
WX1200# set radius key goody
success: change accepted.
WX1200# set radius retransmit 1
success: change accepted.
WX1200# set radius timeout 21
success: change accepted.
See Also
clear radius server on page 489
display aaa on page 219
set radius server on page 494
Causes all RADIUS requests to be sourced from the IP address specified by
the set system ip-address command, providing a permanent source IP
address for RADIUS packets sent from the WX switch.
Syntax —

set radius client system-ip

Defaults — None. If you do not use this command, RADIUS packets
leaving the WX have the source IP address of the outbound interface,
which can change as routing conditions change.
Examples — Enabled.
History —Introduced in MSS Version 3.0.
set radius client system-ip 491