Set {Ap | Dap} Radio Tx-Power - 3Com Wireless LAN Switch WX1200 Command Reference Manual

344 C 11: M
HAPTER
set {ap | dap} radio
tx-power
A P C
ANAGED CCESS OINT OMMANDS
set {ap | dap} radio mode on page 341
set radio-profile mode on page 362
Sets a MAP radio's transmit power.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
tx-power power-level
ap port-list
which to set the transmit power.
dap dap-num
transmit power.
— Radio 1 of the MAP.
radio 1
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
tx-power power-level
1 milliwatt (dBm). The valid values depend on the country of
operation.
The maximum transmit power you can configure on any 3Com radio
is the maximum allowed for the country in which you plan to operate
the radio or one of the following values if that value is less than the
country maximum: on an 802.11a radio, 11 dBm for channel numbers
less than or equal to 64, or 10 dBm for channel numbers greater than
64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for
802.11b, or 14 dBm for all valid channel numbers for 802.11g.
Defaults — The default transmit power on all MAP radio types is the
highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You also can configure a radio's channel on the same
command line. Use the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is
enabled.
— List of ports connected to the MAP access points on
— Number of a Distributed MAP on which to set the
— Number of decibels in relation to