Clear Service-Profile - 3Com Wireless LAN Switch WX1200 Command Reference Manual

clear service-profile

Examples — The following commands disable the radios that are using
radio profile rp1 and reset the beaconed-interval parameter to its
default value:
WX4400# set radio-profile rp1 mode disable
WX4400# clear radio-profile rp1 beacon-interval
success: change accepted.
The following commands disable the radios that are using radio profile
rptest and remove the profile:
WX4400# set radio-profile rptest mode disable
WX4400# clear radio-profile rptest
success: change accepted.
See Also
display radio-profile on page 317
set {ap | dap} radio radio-profile on page 343
set radio-profile mode on page 362
Removes a service profile or resets one of the profile's parameters to its
default value.
Syntax — clear service-profile name
name — Service profile name.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If the service profile is mapped to a radio profile, you must
remove it from the radio profile first. (After disabling all radios that use
the radio profile, use the clear radio-profile name service-profile name
command.)
clear service-profile 289