Set Radius Proxy Port - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set radius proxy
port
Examples — The following command configures a RADIUS proxy entry
for a third-party AP RADIUS client at 10.20.20.9, sending RADIUS traffic
to the default UDP ports 1812 and 1813 on the WX:
WX4400# set radius proxy client address 10.20.20.9 key
radkey1
success: change accepted.
See Also
clear radius proxy client on page 488
set authentication proxy on page 241
set radius proxy port on page 493
Configures the WX port connected to a third-party AP as a RADIUS proxy
for the SSID supported by the AP.
Syntax — set radius proxy port port-list [tag tag-value]
ssid ssid-name
port port-list
tag tag-value
third-party AP for the SSID.
ssid ssid-name
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — AAA for third-party AP users has additional configuration
requirements. See the "Configuring AAA for Users of Third-Party APs"
section in the "Configuring AAA for Network Users" chapter of the
Wireless LAN Switch and Controller Configuration
Enter a separate command for each SSID, and its tag value, you want the
WX to support.
— WX port(s) connected to the third-party AP.
— 802.1Q tag value in packets sent by the
— SSID supported by the third-party AP.

set radius proxy port

Guide.
493