Set Service-Profile Wep Active-Multicast-Index - 3Com Wireless LAN Switch WX1200 Command Reference Manual

388 C 11: M
HAPTER
file:corpa-login.html
file:corpa-logo.jpg
Total:
WX4400# set service-profile corpa-service web-aaa-form corpa-ssid/
corpa-login.html
success: change accepted.
set service-profile
wep
active-multicast-
index
A P C
ANAGED CCESS OINT OMMANDS
1839 bytes used, 206577 Kbytes free
See Also
copy on page 567
dir on page 570
display service-profile on page 321
mkdir on page 580
set port type wired-auth on page 94
set service-profile auth-fallthru on page 374
set web-portal on page 262
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to
use for encrypting multicast frames.
Syntax — set service-profile
name wep active-multicast-index num
name — Service profile name.
num — WEP key number. You can enter a value from 1 through 4.
Defaults — If WEP encryption is enabled and WEP keys are defined,
MAP radios use WEP key 1 to encrypt multicast frames, by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Before using this command, you must configure values for the
WEP keys you plan to use. Use the set service-profile wep key-index
command.
Examples — The following command configures service profile sp2 to
use WEP key 2 for encrypting multicast traffic:
WX4400# set service-profile sp2 wep active-multicast-index 2
success: change accepted.
637 bytes Aug 12 2004, 15:42:26
1202 bytes Aug 12 2004, 15:57:11