3Com Wireless LAN Switch WX1200 Command Reference Manual page 292

292 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
Table 51 Output for display ap config (continued)
Field
name
boot-download-
enable
load balancing group Names of the MAP load-balancing groups to which the MAP
Radio
type
mode
channel
antennatype
tx pwr
profile
auto-tune
max-power
auto-tune
min-client-rate
Description
MAP access point name.
State of the firmware upgrade option:
YES (automatic upgrades are enabled)
NO (automatic upgrades are disabled)
access point belongs. If the value is None, the access point
does not belong to any load balancing groups.
Note: This field is displayed only if the MAP is a member of a
group.
Radio number. The information listed below this field applies
specifically to the radio.
Radio type:
802.11a
802.11b
802.11g
Radio state:
Enabled
Disabled
Channel number.
External antenna model, if applicable.
Transmit power, in dBm.
Radio profile that manages the radio. Until you assign the
radio to a radio profile, MSS assigns the radio to the default
radio profile.
Maximum power level the RF Auto-Tuning feature can set on
the radio.
The value default means RF Auto-Tuning can set the
power up to the maximum level allowed for the country
of operation.
A specific numeric value means you or another
administrator set the maximum value.
Minimum data rate the radio must maintain for associated
clients. When RF Auto-Tuning is enabled, the radio can
temporarily increase its power to maintain the data rate with
an associated client.