3Com Wireless LAN Switch WX1200 Command Reference Manual page 565

The backup command places the boot configuration file into the archive.
(The boot configuration file is the Configured boot configuration in the
display boot command's output.) If the running configuration contains
changes that have not been saved, these changes are not in the boot
configuration file and are not archived. To make sure the archive contains
the configuration that is currently running on the switch, use the
save config command to save the running configuration to the boot
configuration file, before using the backup command.
Examples — The following command creates an archive of the
system-critical files and copies the archive directly to a TFTP server. The
filename in this example includes a TFTP server IP address, so the archive
is not stored locally on the switch.
WX1200#
backup system tftp:/10.10.20.9/sysa_bak critical
success: sent 28263 bytes in 0.324 seconds [ 87231 bytes/sec]
Table 103 describes the fields.
Table 103 Output for backup
Field Description
[tftp:/ip Name of the archive file to create. You can store the file locally in the
-addr/]fil switch's nonvolatile storage or on a TFTP server.
ename
all Backs up system files and all the files in the user files area.
The user files area contains the set of files listed in the file section of dir
command output.
critical Backs up system files only, including the configuration file used when
booting, and certificate files. The size of an archive created by this option
is generally 1MB or less.
See Also
dir on page 570
restore on page 583
backup 565