Set Ip Snmp Server - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set ip snmp server

Examples — The following command adds a default route that uses
gateway 10.5.4.1 and gives the route a cost of 1:
WX4400# set ip route default 10.5.4.1 1
success: change accepted.
The following commands add two default routes, and configure MSS to
always use the route through 10.2.4.69 when the interface to that
gateway router is up:
WX4400# set ip route default 10.2.4.69 1
success: change accepted.
WX4400# set ip route default 10.2.4.17 2
success: change accepted.
The following command adds an explicit route from a WX switch to any
host on the 192.168.4.x subnet through the local router 10.5.4.2, and
gives the route a cost of 1:
WX4400# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1
success: change accepted.
The following command adds another explicit route, using CIDR notation
to specify the subnet mask:
WX4400# set ip route 192.168.5.0/24 10.5.5.2 1
success: change accepted.
See Also
clear ip route on page 130
display interface on page 142
display ip route on page 146
Enables or disables the SNMP service on the wireless LAN switch.
Syntax — set ip snmp server {enable | disable}
enable — Enables the SNMP service.
disable — Disables the SNMP service.
Defaults — The SNMP service is disabled by default.
Access — Enabled.
set ip snmp server 169