Creating An Isp Domain And Configuring Its Attributes - 3Com 4200G 12-Port Configuration Manual

AAA
configuration

Creating an ISP Domain and Configuring Its Attributes

Follow these steps to create an ISP domain and configure its attributes:
To do...
Enter system view
Configure the form of the
delimiter between the
username and the ISP domain
name
Create an ISP domain or set an
ISP domain as the default ISP
domain
Set the status of the ISP
domain
Set the maximum number of
access users that the ISP
domain can accommodate
Set the idle-cut function
Task
Creating an ISP Domain and Configuring Its
Attributes
Configuring separate AAA schemes
Configuring an AAA Scheme for an ISP
Domain
Configuring Dynamic VLAN Assignment
Configuring the Attributes of a Local User
Cutting Down User Connections Forcibly
Use the command...
system-view
domain delimiter { at | dot }
domain { isp-name | default
{ disable | enable isp-name } }
state { active | block }
access-limit { disable |
enable max-user-number }
idle-cut { disable | enable
minute flow }
Required
Required
Required
With separate AAA schemes, you
can specify authentication,
authorization and accounting
schemes respectively.
You need to configure RADIUS or
HWATACACS before performing
RADIUS or HWTACACS
authentication.
Optional
Optional
Optional
—
Optional
By default, the delimiter
between the username and the
ISP domain name is "@".
Required
If no ISP domain is set as the
default ISP domain, the ISP
domain "system" is used as the
default ISP domain.
Optional
By default, an ISP domain is in
the active state, that is, all the
users in the domain are allowed
to request network service.
Optional
By default, there is no limit on
the number of access users
that the ISP domain can
accommodate.
2-2
Remarks
Remarks
Optional
By default, the idle-cut function
is disabled.