Set Snmp Usm - 3Com Wireless LAN Switch WX1200 Command Reference Manual

188 C 7: IP S
HAPTER

set snmp usm

C
ERVICES OMMANDS
See Also
set ip snmp server on page 169
set snmp community on page 175
set snmp notify target on page 181
set snmp notify profile on page 177
set snmp protocol on page 186
set snmp usm on page 188
display snmp status on page 153
Creates a USM user for SNMPv3.
This command does not apply to SNMPv1 or SNMPv2c. For these SNMP
versions, use the set snmp community command to configure
community strings.
Syntax — set snmp usm usm-username
snmp-engine-id {ip ip-addr | local | hex hex-string}
access {read-only | read-notify | notify-only | read-write |
notify-read-write}
auth-type {none | md5 | sha} {auth-pass-phrase string |
auth-key hex-string}
encrypt-type {none | des | 3des | aes} {encrypt-pass-phrase
string | encrypt-key hex-string}
usm-username
32 alphanumeric characters, with no spaces.
snmp-engine-id {ip ip-addr | local | hex hex-string} —
Specifies a unique identifier for the SNMP engine. To send informs,
you must specify the engine ID of the inform receiver. To send traps
and to allow get and set operations and so on, specify local as the
engine ID.
hex hex-string
ip ip-addr
the management application. Enter the IP address of the station.
MSS calculates the engine ID based on the address.
local
— Name of the SNMPv3 user. Specify between 1 and
—ID is a hexadecimal string.
—ID is based on the IP address of the station running
— Uses the value computed from the switch's system IP address.