Set Radio-Profile Preamble-Length - 3Com Wireless LAN Switch WX1200 Command Reference Manual

364 C 11: M
HAPTER
set radio-profile
preamble-length
A P C
ANAGED CCESS OINT OMMANDS
Examples — The following command configures a new radio profile
named rp1:
WX4400# set radio-profile rp1
success: change accepted.
The following command enables the radios that use radio profile rp1:
WX4400# set radio-profile rp1 mode enable
The following commands disable the radios that use radio profile rp1,
change the beacon interval, then reenable the radios:
WX4400# set radio-profile rp1 mode disable
WX4400# set radio-profile rp1 beacon-interval 200
WX4400# set radio-profile rp1 mode enable
The following command enables the WPA IE on MAP radios in radio
profile rp2:
WX4400# set radio-profile rp2 wpa-ie enable
success: change accepted.
See Also
display {ap | dap} config on page 290
display radio-profile on page 317
set {ap | dap} radio mode on page 341
set {ap | dap} radio radio-profile on page 343
Changes the preamble length for which an 802.11b/g MAP radio
advertises support. This command does not apply to 802.11a.
Syntax — set radio-profile
preamble-length {long | short}
name — Radio profile name.
long — Advertises support for long preambles.
short — Advertises support for short preambles.
Defaults — The default is short.
Access — Enabled.
History —Introduced in MSS Version 3.0.
name