Set Ip Https Server; Set Ip Route - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set ip https server

set ip route

Enables the HTTPS server on a wireless LAN switch. The HTTPS server is
required for Web Manager access to the switch.
CAUTION: If you disable the HTTPS server, Web Manager access to the
WX switch is also disabled.
Syntax —
set ip https server {enable | disable}
— Enables the HTTPS server.
enable
— Disables the HTTPS server.
disable
Defaults — The HTTPS server is disabled by default.
Access — Enabled.
History — The default is changed to disabled in 3.1. In addition, the
HTTPS server is no longer required for WebAAA.
Examples — The following command enables the HTTPS server on a WX
switch:
WX1200# set ip https server enable
success: change accepted.
See Also
clear ip telnet on page 131
display ip https on page 145
display ip telnet on page 148
set ip telnet on page 171
set ip telnet server on page 172
Adds a static route to the IP route table.
Syntax —
set ip route {default | ip-addr mask |
ip-addr/mask-length} gateway metric
— Default route. A WX switch uses the default route if an
default
explicit route is not available for the destination.
Default is an alias for IP address 0.0.0.0/0.
set ip https server 167