Reset System - 3Com Wireless LAN Switch WX1200 Command Reference Manual

582 C 20: F
HAPTER ILE

reset system

M C
ANAGEMENT OMMANDS
Restarts an WX switch and reboots the software.
Syntax —
reset system [force]
— Immediately restarts the system and reboots, without
force
comparing the running configuration to the configuration file.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you do not use the force option, the command first
compares the running configuration to the configuration file. If the
running configuration and configuration file do not match, MSS does not
restart the WX switch but instead displays a message advising you to
either save the configuration changes or use the force option.
Examples — The following command restarts an WX switch that does
not have any unsaved configuration changes:
WX4400# reset system
This will reset the entire system. Are you sure (y/n)y
The following commands attempt to restart an WX switch with a running
configuration that has unsaved changes, and then force the switch to
restart:
WX4400# reset system
error: Cannot reset, due to unsaved configuration changes.
Use "reset system force" to override.
WX4400# reset system force
...... rebooting ......
See Also
display boot on page 573
display version on page 576
save config on page 584