Set Spantree Backbonefast - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set spantree
backbonefast
Examples — The following command enables STP on all VLANs
configured on a WX switch:
WX4400# set spantree enable
success: change accepted.
The following command disables STP on VLAN burgundy:
WX4400# set spantree disable vlan burgundy
success: change accepted.
See Also
display spantree on page 398
Enables or disables STP backbone fast convergence on a wireless LAN
switch. This feature accelerates a port's recovery following the failure of
an indirect link.
CAUTION: The backbone fast convergence feature is not compatible
with switches that are running standard IEEE 802.1D Spanning Tree
implementations. This includes switches running Rapid Spanning Tree or
Multiple Spanning Tree.
Syntax — set spantree backbonefast {enable | disable}
enable — Enables backbone fast convergence.
disable — Disables backbone fast convergence.
Defaults — STP backbone fast path convergence is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you plan to use the backbone fast convergence feature, you
must enable it on all the bridges in the spanning tree.
Examples — The following command enables backbone fast
convergence:
WX4400# set spantree backbonefast enable
success: change accepted.

set spantree backbonefast

411