Set Radio-Profile Auto-Tune Power-Config - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set radio-profile
auto-tune
power-config
set {ap | dap} radio auto-tune max- retransmissions on page 337
set radio-profile auto-tune power-config on page 353
set radio-profile auto-tune power-interval on page 354
Enables or disables dynamic power tuning (RF Auto-Tuning) for the MAP
radios in a radio profile.
Syntax —
set radio-profile name auto-tune power-config
{enable | disable}
— Radio profile name.
name
— Configures radios to dynamically set their power levels
enable
when the MAPs are started.
— Configures radios to use their statically assigned power
disable
levels, or the default power levels if unassigned, when the radios are
started.
Defaults — Dynamic power assignment is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — When RF Auto-Tuning for power is disabled, MSS does not
dynamically set the power levels when radios are first enabled and also
does not tune power during operation with associated clients.
When RF Auto-Tuning for power is enabled, MSS does not allow you to
manually change the power level.
Examples — The following command enables dynamic power tuning for
radios in the rp2 radio profile:
WX4400# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
See Also
set {ap | dap} radio auto-tune max-power on page 335
set {ap | dap} radio auto-tune max- retransmissions on page 337
set radio-profile auto-tune channel-config on page 349

set radio-profile auto-tune power-config

353