Set {Ap | Dap} Radio Antennatype - 3Com Wireless LAN Switch WX1200 Command Reference Manual

334 C 11: M
HAPTER
set {ap | dap} radio
antennatype
A P C
ANAGED CCESS OINT OMMANDS
Examples — The following command changes the name of the MAP
access point on port 1 to techpubs:
WX1200# set ap 1 name techpubs
success: change accepted.
See Also
display {ap | dap} config on page 290
Sets the model number for an external antenna.
Syntax —
set {ap port-list | dap dap-num} radio {1|2} antennatype
{ANT1060 | ANT1120 | ANT1180 |
ANT5060 | ANT5120 | ANT5180 |
ANT-1360-OUT | ANT-5360-OUT |ANT-5120-OUT | internal}
ap port-list
which to set the channel.
dap dap-num
channel.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
antennatype {ANT1060 | ANT1120 | ANT1180 | internal}
802.11b/g external antenna models:
ANT1060
ANT1120
ANT1180
internal
antennatype {ANT5060 | ANT5120 | ANT5180 | internal}
802.11a external antenna models:
ANT5060
ANT5120
ANT5180
internal
— List of ports connected to the MAP access points on
— Number of a Distributed MAP on which to set the
— 60° 802.11b/g antenna
— 120° 802.11b/g antenna
— 180° 802.11b/g antenna
— uses the internal antenna instead
— 60° 802.11a antenna
— 120° 802.11a antenna
— 180° 802.11a antenna
— uses the internal antenna instead
—
—