3Com Wireless LAN Switch WX1200 Command Reference Manual page 342

342 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
mode enable — Enables a radio.
— Disables a radio.
mode disable
Defaults — MAP access point radios are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Usage — To enable or disable one or more radios to which a profile is
assigned, use the set ap radio radio-profile command. To enable or
disable all radios that use a specific radio profile, use the set
radio-profile command.
Examples — The following command enables radio 1 on the MAP access
points connected to ports 1 through 5:
WX1200# set ap 1-5 radio 1 mode enable
success: change accepted.
The following command enables radio 2 on ports 1 through 3:
WX1200# set ap 1-3 radio 2 mode enable
success: change accepted.
See Also
clear {ap | dap} radio on page 286
display {ap | dap} config on page 290
set {ap | dap} radio radio-profile on page 343
set radio-profile mode on page 362