Set Rfdetect Signature; Set Rfdetect Ssid-List - 3Com Wireless LAN Switch WX1200 Command Reference Manual

560 C 19: RF D
HAPTER
set rfdetect
signature

set rfdetect ssid-list

C
ETECTION OMMANDS
Enables MAP signatures. A MAP signature is a set of bits in a
management frame sent by a MAP that identifies that MAP to MSS. If
someone attempts to spoof management packets from a 3Com MAP,
MSS can detect the spoof attempt.
Syntax —
set rfdetect signature {enable | disable}
— Enables MAP signatures.
enable
— Disables MAP signatures.
disable
Defaults — MAP signatures are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0.
Usage — The command applies only to MAPs managed by the WX
switch on which you enter the command. To enable signatures on all
MAPs in a Mobility Domain, enter the command on each WX switch in
the Mobility Domain.
You must use the same MAP signature setting (enabled or disabled) on all
WX switches in a Mobility Domain.
Examples — The following command enables MAP signatures on a WX
switch:
WX1200# set rfdetect signature enable
success: signature is now enabled.
Adds an SSID to the permitted SSID list.The permitted SSID list specifies
the SSIDs that are allowed on the network. If MSS detects packets for an
SSID that is not on the list, the AP that sent the packets is classified as a
rogue. MSS issues countermeasures against the rogue if they are
enabled.
Syntax —
set rfdetect ssid-list ssid-name
ssid-name
— SSID name you want to add to the permitted SSID list.