Load Config - 3Com Wireless LAN Switch WX1200 Command Reference Manual

578 C 20: F
HAPTER ILE

load config

M C
ANAGEMENT OMMANDS
Table 106 Output for display version (continued)
Field
Hardware
Serial number
Flash
Kernel
BootLoader
Port/DAP
AP Model
Serial #
Versions
See Also
display boot on page 573
Loads configuration commands from a file and replaces the WX switch's
running configuration with the commands in the loaded file.
CAUTION: This command completely removes the running configuration
and replaces it with the configuration contained in the file. 3Com
recommends that you save a copy of the current running configuration to
a backup configuration file before loading a new configuration.
Syntax — load config [url]
url — Filename. Specify between 1 and 128 alphanumeric characters,
with no spaces.
If the file is in a subdirectory, specify the subdirectory name, followed
by a forward slash, in front of the filename. For example:
backup_configs/config_c.
Defaults — The default file location is nonvolatile storage.
The current version supports loading a configuration file only from the
switch's nonvolatile storage. You cannot load a configuration file directly
from a TFTP server.
Description
Version information for the WX switch's motherboard and
Power over Ethernet (PoE) board.
Serial number of the WX switch.
Flash memory version.
Kernel version.
Boot code version.
Port number connected to a MAP access point.
MAP model number.
MAP serial number.
MAP hardware, firmware, and software versions.