314
C
11: M
HAPTER
display dap global
A
P
C
ANAGED
CCESS
OINT
OMMANDS
The following command displays connection information specifically for a
Distributed MAP with serial ID M9DE48B6EAD00:
WX1200# display dap connection serial-id M9DE48B6EAD00
Total number of entries: 1
DAP Serial Id
--- -----------
9
M9DE48B6EAD00 10.10.4.88
Table 60 describes the fields in this display.
Table 60 Output of display dap connection
Field
DAP
Serial Id
DAP IP Address
WX IP Address
See Also
display {ap | dap} config on page 290
display dap global on page 314
display dap unconfigured on page 316
Displays connection information for Distributed MAPs configured on a
WX switch.
Syntax —
display dap global [dap-num | serial-id serial-ID]
dap-num
— Number of a Distributed MAP for which to display
configuration settings.
serial-id serial-ID
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
DAP IP Address
--------------- ---------------
Description
Connection ID you assigned to the Distributed MAP.
If the connection is configured on another WX switch, this
field contains a hyphen ( - ).
Serial ID of the Distributed MAP.
IP address assigned by DHCP to the Distributed MAP.
System IP address of the WX switch on which the MAP has
an active connection. This is the switch that the MAP used
for booting and configuration and is using for data transfer.
— MAP access point serial ID.
WX IP Address
10.9.9.11