Set Ntp Server - 3Com Wireless LAN Switch WX1200 Command Reference Manual

174 C 7: IP S
HAPTER

set ntp server

C
ERVICES OMMANDS
Configures a wireless LAN switch to use an NTP server.
Syntax —
set ntp server ip-addr
— IP address of the NTP server, in dotted decimal notation.
ip-addr
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can configure up to three NTP servers. MSS queries all the
servers and selects the best response based on the method described in
RFC 1305, Network Time Protocol (Version 3) Specification,
Implementation and Analysis.
To use NTP, you also must enable the NTP client with the set ntp
command.
Examples — The following command configures a WX switch to use
NTP server 192.168.1.5:
WX4400# set ntp server 192.168.1.5
See Also
clear ntp server on page 131
clear ntp update-interval on page 132
display ntp on page 149
set ntp on page 173
set ntp update-interval on page 175