Display Dap Connection - 3Com Wireless LAN Switch WX1200 Command Reference Manual

display dap
connection
Displays the system IP address of the WX switch that booted a Distributed MAP.
Syntax —

display dap connection

[dap-num | serial-id serial-ID]
— Number of a Distributed MAP for which to display
dap-num
information about its active connection.
serial-id serial-ID
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The serial-id parameter displays the active connection for the
specified Distributed MAP even if that MAP is not configured on this WX
switch. If you instead use the command with the dap-num parameter or
without a parameter, connection information is displayed only for
Distributed MAPs that are configured on this WX switch.
This command provides information only if the Distributed MAP is
configured on the switch where you use the command. The switch does
not need to be the one that booted the MAP, but it must have the MAP
in its configuration. Also, the switch that booted the MAP must be in the
same Mobility Domain as the switch where you use the command.
If a Distributed MAP is configured on this WX switch (or another WX
switch in the same Mobility Domain) but does not have an active
connection, the command does not display information for the MAP. To
show connection information for Distributed MAPs, use the display dap
global command on one of the switches where the MAPs are
configured.
Examples — The following command displays information for all
Distributed MAPs configured on this WX switch that have active
connections:
WX1200# display dap connection
Total number of entries: 2
DAP Serial Id
--- -----------
2 M9DE48B012F00 10.10.2.27
4 M9DE48B123400 10.10.3.34
— MAP access point serial ID.
DAP IP Address WX IP Address
--------------- ---------------
10.3.8.111
10.3.8.111
display dap connection 313