Set Trace Authorization - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set trace
authorization
Examples — The following command starts a trace for information
about user jose's authentication:
WX4400# set trace authentication user jose
success: change accepted.
See Also
clear trace on page 590
display trace on page 591
Traces authorization information.
Syntax — set trace authorization [mac-addr mac-address]
[port port-num] [user username] [level level]
mac-addr mac-address
address, using colons to separate the octets (for example,
00:11:22:aa:bb:cc).
port port-num — Traces on a WX a port number.
user username — Traces a user. Specify a username of up to
80 alphanumeric characters with no spaces.
level level — Determines the quantity of information included in
the output. You can set the level with an integer from 1 to 10, where
level 10 provides the most information. Levels 1 through 5 provide
user-readable information. If you do not specify a level, level 5 is the
default.
Defaults — The default trace level is 5.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command starts a trace for information for
authorization for MAC address 00:01:02:03:04:05:
WX4400# set trace authorization mac-addr 00:01:02:03:04:05
success: change accepted.

set trace authorization

— Traces a MAC address. Specify a MAC
593