3Com Wireless LAN Switch WX1200 Command Reference Manual page 367

Table 67 Defaults for Service Profile Parameters (continued)
Parameter
auth-fallthru
auth-psk
beacon
cipher-ccmp
cipher-tkip
cipher-wep104
cipher-wep40
psk-phrase
psk-raw
rsn-ie
shared-key-auth
ssid-name
ssid-type
tkip-mc-time
set radio-profile service-profile
Radio Behavior When Parameter Set
Default Value to Default Value
web-auth Uses WebAAA for users who do not
match an 802.1X or MAC authentication
rule for the SSID requested by the user.
disable Does not support using a preshared key
(PSK) to authenticate WPA clients.
enable Sends beacons to advertise the SSID
managed by the service profile.
disable Does not use Counter with Cipher Block
Chaining Message Authentication Code
Protocol (CCMP) to encrypt traffic sent to
WPA clients.
enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP) to
encrypt traffic sent to WPA clients.
disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt traffic
sent to WPA clients.
disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
No passphrase Uses dynamically generated keys rather
defined than statically configured keys to
authenticate WPA clients.
No preshared Uses dynamically generated keys rather
key defined than statically configured keys to
authenticate WPA clients.
disable Does not use the RSN IE in transmitted
frames.
disable Does not use shared-key authentication.
This parameter does not enable PSK
authentication for WPA. To enable PSK
encryption for WPA, use the
set radio-profile auth-psk command.
private Uses the SSID name private.
crypto Encrypts wireless traffic for the SSID.
60000 Uses Michael countermeasures for 60,000
ms (60 seconds) following detection of a
second MIC failure within 60 seconds.
367