Set System Ip-Address - 3Com Wireless LAN Switch WX1200 Command Reference Manual

192 C 7: IP S
HAPTER
set system
ip-address
C
ERVICES OMMANDS
Examples — To enable summertime and set the summertime time zone
to PDT (Pacific Daylight Time), type the following command:
WX1200# set summertime PDT
success: change accepted
See Also
clear summertime on page 135
clear timezone on page 136
display summertime on page 154
display timedate on page 155
display timezone on page 155
set timedate on page 193
set timezone on page 194
Configures the system IP address. The system IP address determines the
interface or source IP address MSS uses for system tasks, including the
following:
Mobility domain operations
Topology reporting for dual-homed MAP access points
Default source IP address used in unsolicited communications such as
AAA accounting reports and SNMP traps
Syntax — set system ip-address ip-addr
ip-addr — IP address, in dotted decimal notation. The address must
be configured on one of the WX switch's VLANs.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must use an address that is configured on one of the WX
switch's VLANs.
To display the system IP address, use the display system command.