3Com Wireless LAN Switch WX1200 Command Reference Manual page 190

190 C 7: IP S
HAPTER ERVICES
C
OMMANDS
If the encryption type is des, 3des, or aes, you can specify a
passphrase or a hexadecimal key.
To specify a passphrase, use the encrypt-pass-phrase string
option. The string can be from 8 to 32 alphanumeric characters
long, with no spaces.
To specify a key, use the encrypt-key hex-string option.
Defaults — No SNMPv3 users are configured by default. When you
configure an SNMPv3 user, the default access is read-only, and the
default authentication and encryption types are both none.
Access — Enabled.
History — Introduced in MSS Version 4.0.
Examples — The following command creates USM user snmpmgr1,
associated with the local SNMP engine ID. This user can send traps to
notification receivers.
WX#1200 set snmp usm snmpmgr1 snmp-engine-id local
success: change accepted.
The following command creates USM user securesnmpmgr1, which uses
SHA authentication and 3DES encryption with passphrases. This user can
send informs to the notification receiver that has engine ID 192.168.40.2.
WX4400# set snmp usm securesnmpmgr1 snmp-engine-id ip
192.168.40.2 auth-type sha auth-pass-phrase myauthpword
encrypt-type 3des encrypt-pass-phrase mycryptpword
success: change accepted.
See Also
clear snmp usm on page 134
set ip snmp server on page 169
set snmp community on page 175
set snmp notify target on page 181
set snmp notify profile on page 177
set snmp protocol on page 186
set snmp security on page 187
display snmp usm on page 154