Set Snmp Notify Target; Snmpv3 With Informs - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set snmp notify
target

SNMPv3 with Informs

WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedMacAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectSpoofedSsidAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedAPTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedOuiTraps
success: change accepted.
WX1200# set snmp notify profile snmpprof_rfdetect send
RFDetectUnAuthorizedSsidTraps
success: change accepted.
See Also
clear snmp notify profile on page 133
set ip snmp server on page 169
set snmp community on page 175
set snmp notify target on page 181
set snmp protocol on page 186
set snmp security on page 187
set snmp usm on page 188
set snmp notify profile on page 177
Configures a notification target for notifications from SNMP.
A notification target is a remote device to which MSS sends SNMP
notifications. You can configure the MSS SNMP engine to send
confirmed notifications (informs) or unconfirmed notifications (traps).
Some of the command options differ depending on the SNMP version
and the type of notification you specify. You can configure up to 10
notification targets.
To configure a notification target for informs from SNMPv3, use the
following command:

set snmp notify target

181