Clear Port Preference - 3Com Wireless LAN Switch WX1200 Command Reference Manual

clear port
preference
Examples — The following command clears the names of ports 1
through 3:
WX4400# clear port 1-3 name
See Also
display port status on page 73
set port name on page 86
Resets a gigabit Ethernet port on a WX4400 to use the GBIC (fiber)
interface for the active link.
Syntax —
clear port preference port-list
— List of physical ports. MSS clears the preference on all
port-list
the specified ports.
Defaults — When both the copper and fiber interfaces of a gigabit
Ethernet port are connected, the GBIC (fiber) interface is the active link.
The RJ-45 (copper) link is unused.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400. This command
does not affect a link that is already active on the port.
Examples — The following command clears the preference set on port 2
on a WX4400 switch:
WX4400# clear port preference 2
See Also
display port preference on page 72
set port preference on page 88

clear port preference

67