Set Log - 3Com Wireless LAN Switch WX1200 Command Reference Manual

614 C 23: S
HAPTER YSTEM
WX4400# display log trace facility ?
<facility name>
ASO, BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,
IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE,
SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MAP,
RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.

set log

L C
OG OMMANDS
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — Type the following command to see the facilities for which
you can view event messages archived in the buffer:
Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP,
See Also
clear log on page 609
display log config on page 612
Enables or disables logging of WX and MAP events to the WX log buffer
or other logging destination and sets the level of the events logged. For
logging to a syslog server only, you can also set the facility logged.
Syntax — set log {buffer | console | current | server ip-addr
| sessions | trace} [severity severity-level] enable | disable]
Syntax — set log server ip-addr [severity severity-level
[local-facility facility-level]] [enable | disable]
buffer — Sets log parameters for the log buffer in nonvolatile
storage.
console — Sets log parameters for console sessions.
current — Sets log parameters for the current Telnet or console
session. These settings are not stored in nonvolatile memory.
server ip-addr
address in dotted decimal notation.
sessions — Sets the default log values for Telnet sessions. You can
set defaults for the following log parameters:
Severity
— Sets log parameters for a syslog server. Specify an