Wan Configuration And Testing Connectivity - Avaya G430 Manual

Root level command

WAN configuration and testing connectivity

Commands used for WAN configuration and testing connectivity
After configuring the new interface, you can perform the following tests to verify that the new
interface is operating correctly.
• For the USB-modem interface and the Fast Ethernet interface, use the show
interfaces command to verify that all line signals are up. For example:
DCD = up DSR = up DTR = up RTS = up CTS = up
• Use the show traffic-shape command to view traffic shaping configuration
parameters for all interfaces.
• Use the show ip interface command to display information about IP interfaces. To
display information about a specific interface, include the name of the interface as an
argument. To display information about the interface of a specific IP address, include the
IP address as an argument.
• Enter show running-config to display the configuration running on the device.
• Enter show startup-config to display the configuration loaded at startup.
• Use the ping command to send ICMP echo request packets to another node on the
network. Each node is periodically pinged and checked if an answer was received. This
checks host reachability and network connectivity.
Administering Avaya G430 Branch Gateway
Command
pppoe-client
persistent delay
pppoe-client
persistent max-
attempts
pppoe-client
service-name
pppoe-client
wait-for-ipcp
shutdown
Description
Set the interval between pppoe-client
dial attempts
Limit the number of consecutive
connection establishment retries
Set the PPPoE Client service-name
Set the amount of time (in seconds)
between establishment of the PPPoE
tunnel and establishment of the IPCP
tunnel. If this time is exceeded, the
PPPoE client terminates the PPPoE
tunnel.
Shut down the port, and the PPPoE
client, if configured
WAN interfaces
October 2013 255