Avaya G430 Manual page 164

Standard Local Survivability (SLS)
Note:
Review
proceeding with SLS administration. This summary of SLS commands guides you in
understanding the various sub-commands of each sub-context.
Creating the SLS administration data set on the Branch Gateway
Procedure
1. Log on to the Branch Gateway.
2. To administer the name, enter set system name name, where name is typed
3. At the Branch Gateway command prompt, enter sls to begin entering SLS data.
4. Enter set pim-lockout yes to prevent Provisioning and Installation Manager
5. If you want to change the maximum allowable IP registrations from the default, enter
6. Use the set date-format command to set a date format for the SLS data set.
7. Use the set ip-codec-set command to select the country-specific G.711 codec
8. Administer the slot configuration information by entering set slot-config
9. Administer the station information.
10. Administer DS1 trunks as required.
164 Administering Avaya G430 Branch Gateway
Summary of SLS configuration commands
inside quotation marks ("").
To remove the administered name, enter set system name, and then rename
the Branch Gateway using the set system name command.
Note:
The Branch Gateway's administered name must match the name in the
Communication Manager administration.
The command line prompt changes to (super-sls)# to indicate that you are in SLS
data entry mode. Entering exit ends the SLS data entry mode session, and the
command line prompt returns to its original state.
(PIM) updates while you are working on SLS administration of the Branch
Gateway.
set max-ip-registrations n, where n is from 1 to 150.
set within the SLS data set: g.711mu or g.711a.
slot-number board-type, where slot-number is the slot where the Media
Module is located and board-type is the Media Module type.
See Media module compatibility with SLS
See Administering station parameters
Refer to Administering DS1 parameters
Comments? infodev@avaya.com
on page 187 in its entirety before
on page 102
on page 166.
on page 170.
October 2013