Avaya G430 Manual page 493

Procedure
1. Use the crypto isakmp peer-group command, followed by the name of a peer-
2. Use the description command to enter a description for the ISAKMP peer-
3. Add a peer to the list of peers in the group, using the set peer command:
4. Repeat Step
Configuring crypto maps
About this task
A crypto map points to a transform-set and to a peer that in turn points to an ISAKMP policy.
If you defined a peer-group, the crypto map can point to the peer-group. The transform-set and
ISAKMP policy define how to secure the traffic that matches the ip-rule that points to this crypto
map.
Important:
It is mandatory to create at least one crypto map.
Administering Avaya G430 Branch Gateway
group (a string of up to 110 characters), to enter the context of an ISAKMP peer-
group (and to create the peer-group if it does not exist).
For example:
Gxxx-001# crypto isakmp peer-group NY-VPN-group
Gxxx-001(config-peer-grp:NY-VPN-group)#
group.
For example:
Gxxx-001(config-peer-grp:NY-VPN-group)# description "Avaya peer group"
Done!
Specify the peer's name or address.
Note:
You can define up to a maximum of five peers in a peer-group.
Important:
Each of the peers listed in the peer-group must be configured as an ISAKMP peer
(see Configuring ISAKMP peer information
Optionally enter an index number, specifying the relative position of the peer within
the peer-group. If you do not enter an index number, the peer is added at the end
of the peer-group list, and is assigned an index following the last peer's index.
For example:
Gxxx-001(config-peer-grp:NY-VPN-group)# set peer 149.49.52.135 1
Done!
3 on page 0
on page 489).
for every peer you want to add to the list.
IPSec VPN
October 2013 493