Avaya G430 Manual page 372

Monitoring applications
A traceroute is performed per RTP session, 10 seconds after the session begins. A traceroute
is not performed if there is another active session to the same destination for which a traceroute
was already performed within the last five seconds.
Procedure
Use the show rtp-stat traceroute command.
You can filter the results according to subnet address by adding destination-ip
and specifying the remote subnet address and subnet mask, or by specifying the rtp-
statistics session index.
For example:
Gxxx-001(super)# show rtp-stat traceroute destination-ip 10.2.5.0
255.255.255.0
Session ID: 1234
From: 123.21.11.5, To: 10.2.4.15, At: 2004-12-26,12:21:55
TTL HOP ADDRESS
--- ---------------
1
2
3
4
Session ID: 1234
From: 123.21.11.5, To: 10.2.4.5, At: 2004-12-26,13:30:15
Result
Note:
The traceroute results are displayed with the most recent first.
RTP traceroute results output
Name
Session ID
From
To
At
TTL
HOP ADDRESS
DELAY
372 Administering Avaya G430 Branch Gateway
DELAY
--------
123.21.11.1
212.201.233.102
213.21.51.12
10.2.4.15
Comments? infodev@avaya.com
2ms
65ms
110ms
175ms
Description
The RTP statistics index for the RTP session
The IP address of the Branch Gateway
The IP address of the session destination (in
this case, a destination within the specified
subnet)
The time the traceroute is performed
The hop count and TTL field value of probe
packets
The hop IP address
The round trip time per probe packet. Three
probe packets are sent per hop address, and
the displayed value is the average of the
October 2013