Avaya G430 Manual page 86

Basic device configuration
Note:
When downloading firmware from the S8300, use only the file name, without the directory
path, in the command line. Otherwise, the procedure will fail. For instance, in the example
above, you must use the following command:
When downloading firmware from the S8300 using TFTP, you may need to enable the TFTP
service in the Set LAN Security parameters of your web server.
Example
The following example downloads a firmware version with the path and file name C:
\gxxx.net from an FTP server with the IP address 149.49.134.153 to Bank A of the Branch
Gateway.
copy ftp SW_imageA C:\gxxx.net 149.49.134.153
Upgrading software and firmware using a USB mass storage device
About this task
You can upgrade software and firmware using a USB mass storage device.
Procedure
1. Obtain an upgrade file from Avaya and place it on your PC.
2. Insert the USB mass storage device into the PC's USB port, and copy the software
3. Remove the USB storage device from the PC, and insert it in the Branch Gateway
4. Copy the software or firmware files to the Branch Gateway using one of the following
86 Administering Avaya G430 Branch Gateway
or firmware file(s) to the USB mass storage device.
USB port.
commands:
• copy usb SW_imageA
• copy usb SW_imageB
• copy usb EW_archive
• copy usb module
• copy usb phone-imageA (or imageB, or imageC, or imageD)
• copy usb phone-scriptA (or phone-scriptB)
• copy usb announcement-file
• copy usb auth-file
• copy usb startup-config
Comments? infodev@avaya.com
October 2013